What would be the best way to setup my lwatercooling loop in haf -x case

May well be a dodgy O-ring if it's tightened properly. Can you tell which part of the fitting it's coming from ie; the block or the tube end?

If it is that and you don't have any spares, you could use some plumbers tape to assist at a pinch.

If it isn't that, you may well just have a dodgy fitting and it needs replacing.
 
Yes its the black and tube end but its not the block I used some paper and it seems ro be the fitting. I dont have any plumber's tape, and i only have strate fittings. will this issue damage my pc ?
 
Sorry, I meant the block or tube end of the fitting itself. It's not that important either way. I was just seeing if you could see exactly where it was leaking from.

If it continuously leaks into your pc around the cpu area and above the gpu, then yes, it will end up damaging your pc if you attempt to use it in that state.

Do you have any spare fittings that you could nick the rubber O-ring(s) from?
 
ok ive got it working, luckily I put a plastic sheet and paper down when testing, I changed the fitting to a straight one and change the tubing, I did have a monsoon led fitting I wanted to use but the quality is so bad I it stopped working with 2 mins.

one thing i did notice is my pc seems faster now even without overclocking.
 
finally done.

20140425_184703.jpg

20140425_184523.jpg

20140425_185114.jpg
 
Last edited:
Yes, got there,
I'm not sure about flowing but it seems ok to me, and no leaks now.

I do get a bit worried now, im always thinking what if it starts leaking
 
Last edited:
there was a issue a few mins ago, all of a sudden i started red lines across the screen, so i restarted my pc, it would load fine upto windows and then i had red lines with black background, turned the pc off removed the gfx card and re installed it and the pc is working fine again, is there anything i should be worried about ?
 
Its hqppening againg some times the screen goes blanknothers im getting lines or squares. what should I do ? I dont know what this is happening its been fine for the past 24hrs now its started acting up
 
power seems a bit weak, the tube from the cpu block to the rad and the rad to the res seam emprty you cant feel much water moing unlike the from pump to cpu block
 
You must log in or register to reply here.
Back
Top Bottom