***The Vapers Lounge*** 3.0

toasteh said:
Argh, still waiting for my battlestar to show up before I can try mine :( what wattage are you putting through yours?
Click to expand...

I broke the .50 coil in at around 60 watts for a whole tank before whacking it up to the recommended 70-80. Now I'm rocking it at the full 80 and it's a wonderful vape. I daresay you could whack it up a bit higher as it doesn't feel particularly warm.

So glad that Uwell managed to fix the coil issues that plagued the first 2 iterations (particularly the second). Haven't had a single dry hit, even when deliberately chain vaping.
 
So I wouldn't mind getting a two battery MOD.

The RX200 is great, but tiresome lugging it around everywhere. I've seen the Archon which looks quite small (in comparison). Anyone used one, any good? Or anything as small as it, but better?
 
Begbie said:
So I wouldn't mind getting a two battery MOD.

The RX200 is great, but tiresome lugging it around everywhere. I've seen the Archon which looks quite small (in comparison). Anyone used one, any good? Or anything as small as it, but better?
Click to expand...

Smoant Battlestar/Smoant Charon. Take your pick.

https://www.fasttech.com/products/0...ntic-smoant-battlestar-200w-tc-vw-apv-box-mod

https://www.fasttech.com/products/0/10022491/7361403-authentic-smoant-charon-218w-tc-vw-apv-box-mod
 
Where is the best place to get some Samsung INR18650 3500mAh Batteries?

Fasttech charge a preium to ship batteries and for my order it looks like it would be via Sweden Post which im not keen on...
 
@photoshop Unless you are mainly vaping at low wattage (15W - 30W isn) then you will be better off with the 3000mAh 30Qs. The 3500s are only really good for 8A (which is going to be about 33W per battery) and have really bad voltage sag at high currents. What is your mod and what power are you vaping at?
 
Rilot said:
@photoshop Unless you are mainly vaping at low wattage (15W - 30W isn) then you will be better off with the 3000mAh 30Qs. The 3500s are only really good for 8A (which is going to be about 33W per battery) and have really bad voltage sag at high currents. What is your mod and what power are you vaping at?
Click to expand...

Good Point!
I vape around 18/20W

Joyetech V-Tec Mini
Aspire Nautilus X
 
DrToffnar said:
I think I've been spoilt by regulated devices. Mechs are great and all, but I can never get a satisfying hit off of one. I see people throwing REALLY low builds in them and I just think, that cannot possibly be safe. On the rare occasions I break my petri out I'll NEVER go below .25 for fear of stressing the battery too hard. What with a lot of manufacturers flat out LYING about the discharge rates of there batteries and multiple tests stating that even the more respectable brands are in fact overvaluing the amperage rate, I just don't see unregulated as a viable option for me.
Click to expand...

I understand and agree with you.
In my experience, well sourced and legit batteries are the essential ingredient. I always minus a few amps from the stated rating in any case. I tend to use ni80 so i get my hit at 0.30-0.40
I keep the mech stuff for home use and run around with regulated.
 
Sigh, I've no had to escalate a claim via paypal for a recent DNA Vapes purchase, 3 weeks later, no goods, order status is still 'being picked' and their go-to response appears to be "we'll look into it"

After nearly 15 years of not having to use paypals resolution centre I've now had to use it twice in a week, both for vaping related purchases, both UK based.
 
I need a smaller mod hahaha sold my Alien to my friend, and my Lost Vape Triade is too big imo for longer outdoor usage, but need a mod to put the TFV12 on. Cheaper the better as im skinttttt
All I know is I need to get off these tabs again
 
Tesla invader 3, barely bigger then the pair of 18650's it houses, straight up vv, no screen or TC but works a treat.

Just be warned it starts at 3.6v, which can be a little too much the closer you get to it's 0.1ohm limit.
 
Got a bit of a problem. I bought some coils for my Smok Alien with a Baby Beast tank. They are the V8 Baby Q 0.4 Ohms. I've set the Ohms to 0.4 but it doesn't pull well when I take a drag from it. Only a little bit comes out and it feels difficult to take a drag from it. I have no idea what the problem is with these? These should be the same coils as came with the set and I got them from Fast Tech. Can anyone offer any help at all? I really need to get this working soon. Vaping has been nothing but trouble for me. I've obviously not very good at this.

Thanks for any help :).
 
Gee said:
Quick recipe combo for you DIYers.

CAP Double Apple - 4%
CAP Cranberry - 3%
TFA Dragonfruit - 2%

Shake and vape.
Click to expand...

Sounds nice, may end up in the basket when I buy supplies for hics blue razzz this weekend :D

Ammit dual left ft on Sunday, out for delivery today, excellent service yet again.
 
Hey all. Looking to downgrade my cleito 120 to reduce juice consumption and looking for a tank that is a bit more leak proof. Been recommended the UD Athalon 22 mini tank. I've seen this is tpd compliant as it's only a 2ml tank and coils are equally as cheap. 16 bucks from fast tech, anyone got any reviews of it or recommend something else?

Also is there any active discount codes for fast tech at the minute?
 
I am looking at upgrading my aspire cleito / kangertech k-box mini combo.

A friend told me good things about the SMOK Alien kit, but get the TFV8 baby beast to go with it? Would you think that would be a good upgrade?

Currently vaping at 0.2 55W. Does the mod have any contributing factors to how the vape tastes, or literally just there to fire up the liquid?
 
You must log in or register to reply here.
Back
Top Bottom