Can I change the stripe size without loosing data?

I ended up leaving the machine on overnight, not doing anything other than sitting there in the hope it was initialising but there's no change this morning.

When I configured the hard drives I pressed CTRL-R to enter the Perc BIOS and then configured my disks. I didn't do an initialisation on them, just added them to an array. Then I restarted and the Vista X64 setup picked them up correctly and installed.

Now when I ask it to initialise it says all data will be destroyed if I do this. Have I messed up because I should have initalised my array when I set it up?
 
Still fighting with this, think it's basically sorted now! ATTO shows the following:

perc5.jpg
which *I* think looks about kind of right.

HDTune and HDTach both report back around 200Mb/s read which I think is a bit low?
 
You must log in or register to reply here.
Back
Top Bottom