Ek Predator 240 problem

Sorry to necro this but, this morning when I booted I could hear that water injection noise again just as the last one was prior to failure. So I stripped my system down removed the predator unit, checked the water level which was just a tad low. I topped it up and bled the system. I examined the block and see no water stains where there was the last time, I tweaked the hex screws on the block just to ensure they were hand tight. Everything seems back to normal. Is it normal for this to happen? This is how my rev 1 behaved after its first few months of operation. Surely if there was any form of leak it would stain the block just as the other had right? I'm just being extra cautious here, anything I should check for that I already haven't?
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom