Perhaps someone more mechanically minded than myself could take a look at my problem and advise. I have sent a message to Joe from Redsnapper but I doubt he will pick it up untill Monday. (I'm off to Cornwall Sunday?!)
The problem: Whilst using the tripod the leg more or less feel off becuase I turned the leg an extra turn too much!!
The bits: Here's what I have to re assemble!!
1 - thin ring
2 - fat ring
3 - big ring
4 - 2x plastic pads
5 - leg
6 - duo-pod
7 - twist lock tube
What I think I can figure: The fattest two rings wont fit in the actual tripod leg bit as far as I can see. The two white pads clearly sit upon the leg. The thick long ring probably goes somewhere into the locking mechanism. Apart from that I'm stuck. ?? Help??
Please
The problem: Whilst using the tripod the leg more or less feel off becuase I turned the leg an extra turn too much!!
The bits: Here's what I have to re assemble!!
1 - thin ring
2 - fat ring
3 - big ring
4 - 2x plastic pads
5 - leg
6 - duo-pod
7 - twist lock tube
What I think I can figure: The fattest two rings wont fit in the actual tripod leg bit as far as I can see. The two white pads clearly sit upon the leg. The thick long ring probably goes somewhere into the locking mechanism. Apart from that I'm stuck. ?? Help??
Please
Last edited:
). The large plastic washer goes onto the lower leg first with the raised rim bottom most, then the smaller ring followed by the last ring. The two plastic halves then fit onto the end of the thinner tube with the circular lugs in the circular cut out in the tube. Then in the larger tube there are two raised grooves, you can feel these with your finger. The two gaps left between the plastic halves fit into these grooves. Tighten up the twist lock to secure it all and you're sorted! 
