nice one, try and upgrade it to opentx 2.0.13 .....meant to fix a major bug. Not done mine yet but will at some point.
If it's working in baseflight gui, the naze & rx are powering up when you plug the battery in and the ESC's are doing their start-up beeps then it should work.
Things I would do are; (apologies if you've done some of this already)
1) Check ARM hasn't been assigned to an AUX switch (unless you want it to be)
2) Go to the receiver tab in bf, the ranges should go from 1000-2000 on all channels and sit at 1500 when centered. If they don't subtrim the tx until they do. Check they don't need reversing (I have missed this before as some do on the taranis/d4rII)
4) The board won't arm if the throttle input from the rx isn't below the value set for mincheck. You can only check or alter this value in the CLI.
5) Board also wont arm if it's at a greater than 25 degree angle from horizontal.
6) Might be worth going into the AUX tab and setting arm for a switch and see if that works?
Would be good to see a dump from your CLI and some screenies if none of that helps.
Bets place to sell some RC Gear?
I get a steady blue light when its ready to arm so that part of it looks ok.
Ive reflashed the firmware, and charging the battery. Ill give it another go when that's finished.
Thanks chaps!!
Classifieds on Multi-Rotor.co.uk. Expect people to be wary of a new poster selling stuff though. Otherwise the usual Scumtree and FleaBay and expect timewasters and dreamers