Parvum BattleBox Build
- Thread starter joelk2
- Start date
A nice build, bet you are dead chuffed with it
am super chuffed with it. new GPU is on the list but im going to wait for mantle before i make the decision to switch.
Thankyou again to Coolermaster
top cover has been received.
but on the weekend my keyboard stopped working
contacted coolermaster (bearing in mind i havent a receipt and the keyboard is over a year old) and they are sending me a new one FOC. result.
top quality CS from them.
More! More!
Great sleeving, yours and davido's! Did some myself last weekend and it's a nightmare to get it looking good - I messed up the lengths on my PCI-E power cable braid so I had uneven ends... It seems wires used are not a standard length, or all the same!
I don't think sleeving the USB3 connection is going to be possible unless the connection to the front panel is a header rather than soldered... Mine is soldered and there's far too many pins to consider unsoldering, braiding and then resoldering! At least your board has the connection at the bottom, my ROG Max IV has it by the CPU! What were they thinking?!
thanks. its deffo worth having a go at.
i put the sleeve on, stretched to the required length, made a tiny cut, slid it back off a bit and cut it again. i found this method was the most accurate.
i did a fe but measuring it up, stretching it and cutting to the length but it didnt always stretch back to that length when i had stretched it to get over a connector etc.
the more stuff isnt greatly exciting, more of a visual thing than anything else.
as i got a few more things lined up i might wait to do the pictures once ive done those bits too (with postage it means it wouldnt be til after christmas)
thats an odd place to put it yeah.
i very rarely use the front usb so could disconnect if i wanted.