** PHANTEKS ENTHOO PRIMO - THE ULTIMATE WATERCOOLING CHASSIS **

  • Thread starter Thread starter rjk
  • Start date Start date
The PSU is in the boxed in area below the motherboard. But there is still plenty of room for cable management in the front of this boxed area and behind motherboard.

The doors slide in at on front edge, than the back swings in.
 
As best as I can tell the LED strip has 2-pin fan connector with the power coming to the female plug and the male header on the LED strip.
Would put up a couple images but can't seem to get Photobucket to load.

Edit: Here are a couple of images
LEDplugampsocket_zpsc1abef03.jpg
LEDplugampsocket1_zps525735f8.jpg
 
Last edited:
A switch at front on top controls both the fans' LEDs and light strip running along the side of the case. The overall effect is pleasant and not overdone.
Behind it in this order are power reset button, 2x USB 3.0 sockets, 2x USB 2.0 sockets, headphone jack and microphone jack.
 
Here are a few pictures of my latest build, there is still a bit to do, I'm just glad I've got a working pc again.









Yes I've got all my fans pulling air in except the rear 140 and 2 80mm, I tried it the norm with the air flowing from bottom out of the top, but my temps are better this way, They should be even better once I finish my plinth.

At the moment I'm running at an out of box state so no overclock and my temps are. Ambient 23.5, 28, 25, 26, 25, and my fluid temp is 27.1 and my internal case temp is, 26.7. I think it will only improve once the case is rissen up a touch
 
That yellow is awesome mate very nice. I'm new to WC so forgive this question. What is the purpose of the two tubes linking between your cards? I've just used one on my build, is there a benefit or purpose I've missed?
 
Looks good!
What did you do with the optical drive bays? I can't see enough in picture.
Please let us know the temps when you raise your case.
 
Cheers guys, it took a fair bit of mixing to get the pastel yellow more of an MSI yellow.

I'm using a couple of XSPS lcd sensors, one in the res, and the other isjust above the top gpu, for an air reading. for the basic temps it is core temp.

The 2 tubes just makes it look pretty, it's called running them in parallel, there is a lot of debate if it helps or hinders preasure and flow, but I have tried it both ways, and for me it works.

The optical bays have gone mate, it looked too cramped once the res was on the bracket . I've got an idea brewing for something special for the empty space.
 
Quick question, the Hard drive cages, is it possible to remove the bottom one and still have the top one in place?

Reasson i ask as i want to install a 480 Rad in the bottom but also want to install some 3.5" HD's

If you can, how much space will you have left?
 
You can mate but you have to cut the panel I half. There is a dood youtube vid from mawdmen were they go in depth on rad sizes I think the only problem was with black ice rads. With the less than 125 wide that is only the case with the front hard drive bay in place once removed it can take a 140mm.
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom