Associate
Your bends look ok to me 
PHANTEKS EVOLV X & P600S
- Thread starter southernorth
- Start date
Associate
EK RGB d5 pump and res combo. Front rad is 38mm (ek pe360) and top rad is 29mm (gts 360) and tubing is 10/12mm (ek petg)
Soldato
Yeh not bad for a first time,I'm going the old hose route,very nice build mate.
Associate
Thank you. A few flat spots but i can live with that.Your bends look ok to me
Associate
Thank you. I will look forward to seeing some picks.
Associate
Any ETA for the P600S yet?
Associate
Is pump/red 100 or 140?
Associate
140
Associate
- Joined
- 2 Oct 2018
- Posts
- 5
Has anyone tested the optimal fan configuration for the evolv x with air cooling? I currently have 3x 140mm silents wings in the front and one in the back.
Soldato
I have mine on air at the moment cooler Master hyper 212 got 2 gentle typhoons 1850 rpms cooling my 8700k @4.8ghz
2x 140mm on the front 2x 140mm in the roof exhausting air and 140mm on the rear,cooling is very good the cpu fans run full speed and the 140mm run at about 45%.
2x 140mm on the front 2x 140mm in the roof exhausting air and 140mm on the rear,cooling is very good the cpu fans run full speed and the 140mm run at about 45%.
Associate
Guys, what cable to i use to power up the front led's on the evolv x? 
all i see is a female 3 pin. There was no cable to connect to it. the side led is fine, as that goes into the motherboard.
Cheers
all i see is a female 3 pin. There was no cable to connect to it. the side led is fine, as that goes into the motherboard.Cheers
Associate
you only need to connect the SATA 12V cable to the PSU in order for the LEDs to work. You can connect the female 3 pin to a supported D-RGB motherboard. Please check if all the cables are seated. Looks like the cable that powers the front LEDs is disconnected..Guys, what cable to i use to power up the front led's on the evolv x?
Cheers
Associate
Hi,
I have the 12v connected, and then connected to the D-RGB on the motherboard, which lights up the side LED fine. but the front don't light up.
there is a fan looking male connector? do i need to connect that some how?
Do i need the software to get it to work?
So what do i do now?
Thanks
Associate
could you send me images at rma[at]phanteks.com? I will check it out.
Soldato
Check you have not knocked any conecter out.
Associate
This is the 12v connected
This is what's left!
The other connector is connected to the mother board.
So does just the 12v above give the right LCD power to light up also ?
I haven't messed with LCD RGB stuff till now lol
Cheers
Soldato
That's the extension I think for rgb.
Associate
Ok, what i just worked out is, if i hold either button that changes colour etc for few seconds, it enables the front light.
So that's working now. but i either button won't change the colour of the LED's. why would that be
Cheers
So that's working now. but i either button won't change the colour of the LED's. why would that be
Cheers
Associate
If you connect it to the motherboard it disables front panel controls https://youtu.be/2garFvM9Za8Ok, what i just worked out is, if i hold either button that changes colour etc for few seconds, it enables the front light.
So that's working now. but i either button won't change the colour of the LED's. why would that be
Cheers