Problem with MAXDATA computer

MG44 · 3 May 2010 at 14:35

I'm helping a friend who is having some issues with his MAXDATA computer

Spec
1Gb DDR2
350W unbranded
ATI 2600pro 512mb
MOBO, RC410-SB450

when the power is turned on it makes a series of clicking noises and refuses to boot up
it then makes a series of beeps
the graphics card is the problem so i removed it and used on board graphics
this allows to computer to boot up
iv tested the card in my pc and it works fine so am thinking its the pci-e slot or the mother board

any surgestions guys??

Biz.Kid09 · 3 May 2010 at 15:48

Well i would suggest a new pc tbh....yes the motherboard is probably at fault if it works in your pc.....

MG44 · 3 May 2010 at 15:50

yer was thinking a new system, problem of being students we have no money so it might be hard to get one.
no chance of getting a bios update now is there

will check my card in his pc later. if that dosent work the mobo is knackered and il b posting about a low cost pc spec

CAT-THE-FIFTH · 3 May 2010 at 15:51

It could be a PSU issue?? If you have a multimeter you can check the voltages on the various lines under load.

MG44 · 3 May 2010 at 15:53

the card takes its power from the pci e slot does that make a differance??
i think it only has a 20 pin connector didnt see a 12v line when i opened it up

CAT-THE-FIFTH · 3 May 2010 at 15:54

The graphics card will be putting an additional load on the PSU and the PCI-E slot can provide upto 75W.

MG44 · 3 May 2010 at 15:55

how can i test it under load then??? i have a multi meter which pins do i need to measure it from
and how do i do it with out electicuting myself

CAT-THE-FIFTH · 3 May 2010 at 16:03

Here are some guides:

http://www.devhardware.com/forums/p...a-multimeter-how-to-use-it-to-test-75111.html

http://www.ochardware.com/articles/psuvolt/psuvolt.html

http://www.motherboards.org/articles/guides/1487_1.html

To load the 12V line use utilities which are used to test CPU overclocks such OCCT or IBT.

Make sure that your computer is well cooled though,ie, make sure it is in a cool place with decent ventilation.

You may also want to test the 5V line by using a utility which will stress the hard disk a bit such as Crystal Disc Mark.

Most importantly I would back up any important data beforehand.