Project: TITAN 4 !!!!

Nickolp1974 said:
Now this is gonna be epic, well jealous, wish i had your money Kaap :) the case is fantastic.
Click to expand...

I wish I had my money, its all gone now, this is the last build I am going to do for a very long time.

I have just ordered another 2 AX480 rads, I found a problem trying to attach fans to the top of the case, the holes are only big enough to take rad screws so I need to attach a rad to attach the fans lol.
 
Gregster said:
Not a bad shout on the blocks bud and so far the gains are very minimal under water. Under a chiller though, quite big gains ;)

When will you be putting it all together?
Click to expand...

It should be up and running in the next couple of days, I am waiting for 2 more 480mm rads to turn up in the morning, I need to fit one of them to the top of the case so I can attach some fans. The screw holes in the top of the case are only big enough for the type of screws used by rads.

If I don't end up w/cooling the GPUs the CPU is going to have some serious cooling all to its self lol.

One of the reasons I have gone for a reverse type case is it means the GPUs are up the top out of the way and hopefully running cooler. On my corsair case where 3 of the Titans are now, the top one is very close to the rear rad causing them both to get a bit warm.
 
Good luck with the build and I'll be watching closely what you come up with spec wise.

A note of caution though and I post from experience, I'd turn the fans/stickers around so all of the Corsair logos are orientated the same way or you'll have Rossi~ to deal with ;):D:D
 
DavidS14 said:
Good luck with the build and I'll be watching closely what you come up with spec wise.

A note of caution though and I post from experience, I'd turn the fans/stickers around so all of the Corsair logos are orientated the same way or you'll have Rossi~ to deal with ;):D:D
Click to expand...

I had thought about the stickers but it makes keeping the cables neater the way they are.

If I peel off the stickers is there anything underneath.

Just fitted another ran and more fans.

002rkb.jpg
 
Last edited:
It's pretty flat under the sticker but they do come off fairly easy if you warm them up a little. I just rotated the sticker as like you I wanted the cable routing in the right place.
 
DavidS14 said:
What's the clearance like from the bottom of the PSU to the top of the 480, can't really see from the angle of the pics.
Click to expand...

I have not tried it yet, but when I was looking at it earlier it is very tight about 1mm.

At the moment I have got a little problem with the PSU, I posted this earlier in 8 Packs section

http://forums.overclockers.co.uk/showthread.php?t=18498491

If anyone has any ideas I would be very grateful.
 
Last edited:
Looks like a standard 6-Pin PCI-E socket, if it fits then you should be good.

The adapter could have been wired with one molex using a loop but it appears it hasn't and does require 2 molex connections.
Google tells me there are a few others about by the looks of it. There must be a better looking one somewhere. Although i'd be inclined to use the adapter on 2 molex connections, hide it away and use a nice braided 6-Pin PCI-E extension cable.

Also, this may be helpful: http://www.techpowerup.com/forums/showthread.php?t=111509
 
You must log in or register to reply here.
Back
Top Bottom