Soldato
- Joined
- 27 Aug 2005
- Posts
- 3,663
Which brand of units did they fit? I heard that some brands the fans are a lot noisey than others, 1 installer mentioned panasonic was a bad one.
Split Air con
- Thread starter YoungBlood
- Start date
Which brand of units did they fit? I heard that some brands the fans are a lot noisey than others, 1 installer mentioned panasonic was a bad one.
Associate
- Joined
- 19 Aug 2019
- Posts
- 264
Panasonic.
It's not the fans that are noisy; it's the pumps next to them.
It's not the fans that are noisy; it's the pumps next to them.
Some pumps are not quiet - Ideally they should have used a remote the pump.
Ideally as they mentioned you would need gravity to drain water to not worry about a pump.
My installer uses Charles Austin Blue Diamond pumps.
New MICRO BlueDiamond Datasheet with Graph (saturnsales.co.uk)
New MICRO BlueDiamond Datasheet with Graph (saturnsales.co.uk)
Man of Honour
- Joined
- 21 Nov 2004
- Posts
- 46,315
That’s why I have all mine on outer walls with pipes going straight out and with gravity. That’s rubbish if they didn’t give you options. You can get silent pumps, but in my mind it’s just another thing to go wrong and an additional cost in most scenarios.
Man of Honour
- Joined
- 21 Nov 2004
- Posts
- 46,315
Most of the time barely audible on ours, especially the smallest unit - our triple unit is perhaps slightly louder. Even on a 30C+ day quieter than most indoor fans set on medium/high. I think our neighbour was quite surprised.
Well we're getting the 5.5kW version fitted in a fortnight. I'm intrigued as to where they're going to get the electrical feed from, but he says it won't be a problem!
A guy coming around next week to look at increasing the loft hatch size too. I'm still pretty keen on vents for the upstairs rooms rather than wall mounts.
A guy coming around next week to look at increasing the loft hatch size too. I'm still pretty keen on vents for the upstairs rooms rather than wall mounts.
Been considering putting something in my office. It’s a walled off corner of the garage with no connection to the heating system in the house so I primarily want something to keep it warm through winter (Had an electric heater controlled by a cheap timer/thermostat unit this year) with cooling in summer being a bonus (Got a large SW facing window so it can get pretty uncomfortable on a sunny afternoon)
I’m thinking a ducted system with the unit in the garage loft could work pretty well.
I also have a 15U wall mounted cabinet mounted right up by the ceiling with some network kit, UPS and small server in it. One side benefit I’d also like to get is to potentially use the unit to keep the cabinet temperatures down, possibly by ducting cooled air directly into it. Obviously I’d not want to duct warm air into here when the unit is being used for heating so when using a heating/cooling unit in a ducted setup are the warm/cool outlets typically separate or does the unit have a single outlet?
I’m thinking a ducted system with the unit in the garage loft could work pretty well.
I also have a 15U wall mounted cabinet mounted right up by the ceiling with some network kit, UPS and small server in it. One side benefit I’d also like to get is to potentially use the unit to keep the cabinet temperatures down, possibly by ducting cooled air directly into it. Obviously I’d not want to duct warm air into here when the unit is being used for heating so when using a heating/cooling unit in a ducted setup are the warm/cool outlets typically separate or does the unit have a single outlet?
The same coil is used for heating and cooling, the condenser has a reversing valve which diverts the discharge from the compressor to the indoor unit.
You would need to fit an isolation damper for use when heating mode is selected.
Ok, sounds like I’ll just rely on the reduced ambient temperature of the room to keep it under control. This has been my first summer with the cabinet in here and everything seemed to cope when the room temp was at 32 degrees last week so there’s no pressing need to actively cool it, just thought it would be a nice benefit if it was just a case of running some extra ducting.
Hmm, I'd be a bit dubious over this, most manuals call for a circuit breaker and RCD protection. With a 5.5kw system I would imagine that'll mean a 16amp breaker. Plus any reconfiguration of a circuit beyond a simple spur would require an electrician to sign off really.
It’ll likely only need 1500w or so, they’re usually efficient to a factor of 4ish. So it won’t need anything like 16A, maybe 6A, so could be fused to 10A which is pretty standard?
However, I’m not sure what the regs require for these things.
However, I’m not sure what the regs require for these things.
Such a load of rubbish all this electrician nonsense. If your competent just do it yourself.
I have an old shower circuit that I will be repurposing.
We went for a Mitsubishi Heavy Industries 6kw Multi Split Condenser with a 3.5kw mounted unit in the main bedroom and a 5kw mounted unit in the kitchen/living area.
Both units have wireless smart control and is quiet when both units are in operation, I normally need silence when going to sleep and the unit doesn’t stop me from sleeping. It’s been a life saver in this weather is a 3 month old baby - we still use our duvets and our daughter is still able to sleep in her baby sleep bag. There no better feeling than walking into the room after a long hot day and the unit is doing it’s thing.
The installer arranged for a certified Eletrition to wire power into the main box.
We paid around £2.6k.
Both units have wireless smart control and is quiet when both units are in operation, I normally need silence when going to sleep and the unit doesn’t stop me from sleeping. It’s been a life saver in this weather is a 3 month old baby - we still use our duvets and our daughter is still able to sleep in her baby sleep bag. There no better feeling than walking into the room after a long hot day and the unit is doing it’s thing.
The installer arranged for a certified Eletrition to wire power into the main box.
We paid around £2.6k.
Well that argument is as old as time. The thing is if you're a legitimate business you have to abide by the rules, having a "that'll do" attitude and later finding out the installation caused a fire and wasn't certified by an electrician will likely see the end of your business. Not to mention it's dishonest, the price for the job should include all this to begin with.
If you're using both then presumably each is limited to 3kw cooling capacity? Not something you probably encounter though as the bedroom one won't be on during the day and vice versa?
We do sometimes use both at the same time - we keep the downstairs unit on overnight as that’s where the dog sleeps. Performance doesn’t seem to be impacted.