SSUPD MeshLicious (from the makers of the FormD T1)
- Thread starter Pocket10s
- Start date
Probs wouldn't fit either but would stand up quite nicely alongside the cabinet I guess
I ended up ordering the rounded feet available from 3DPCbyJay over on Etsy. Happy with them, but have been thinking recently of swapping them out for more traditional speaker feet/stands. Loads of those available on Amazon.No posts for over two months?!
Can anyone recommend some small feet for this case, either screw-on or just larger stick-on rubber feet?
Just need to raise it a little bit.
Partly why i'm looking to replace mine. I added some larger rubber sticky pads to the underside of the printed feet. But looking to get some larger round feet i think.
I like the 'bar' type feet from SFFParts on Etsy, especially as they re-use the original rubber pads but they're shipped from the US and I'm not paying £35 for them!
EDIT: Tbh, I'd be content with the same type of feet as the standard ones, i.e. stick-on rubber blocks, just a bit thicker/higher, if anyone has any ideas. Can't seem to find anything today!
EDIT: Tbh, I'd be content with the same type of feet as the standard ones, i.e. stick-on rubber blocks, just a bit thicker/higher, if anyone has any ideas. Can't seem to find anything today!
Last edited:
No posts for over two months?!
Can anyone recommend some small feet for this case, either screw-on or just larger stick-on rubber feet?
Just need to raise it a little bit.
Theres some 3d printable ones on the SSUPD site, there's a few different options.
I printed some and they create a decent gap under the case for the GPU air to come out of, really helps with temps.
I re-used the rubber pads that come with the case as standard and just stuck them on the bottom of my 3d printed feet..
Last edited:
I Going to do another Build in the 'SSUPD MeshLicious' Was thinking of the 'Ssupd Meshroom'
but A : Can't get hold of Snow white version. B: really not Much different, only its bit more larger to take Full size ATX main change.
but A : Can't get hold of Snow white version. B: really not Much different, only its bit more larger to take Full size ATX main change.
Last edited:
I'd absoluetly do another build in the Meshy, not built into the Meshroom, but then no need to.
Also did a build in an NZXT H1v2 and its not as good as the Meshy.
Done a build in a Fractal Node 304 which is a nice iTX 'server' case given the drive space in it.
If I was to do another iTX build I'd probably look at the NR200 as that was the other iTX case on my list.
Also did a build in an NZXT H1v2 and its not as good as the Meshy.
Done a build in a Fractal Node 304 which is a nice iTX 'server' case given the drive space in it.
If I was to do another iTX build I'd probably look at the NR200 as that was the other iTX case on my list.
Been a while since posting in here. I've just tried swapping my front fans from exhaust to intake which has helped my 5800X3D quite a bit (temps a bit but mostly noise excluding GPU). Is there anywhere in the UK we can get a dual 60mm fan rear pci-e bracket to help the GPU a bit?
Amazing, very kind of the offer! Looks like this one is edited to fit with the 3 slot GPU mode to fit deeper CPU coolers (I have the central spine in mine screwed closer to the GPU side so more space motherboard side). Thanks Trig
