Im still loving this vaping lark, recently got myself a nice stainless steel Vamo (VV&VW), bloody awesome bit of kit, transformed the bulli a2-tm into a beast - On that note anyone know how to oxidise the mesh, fancy trying a straight ss mesh wick instead of the silica/mesh combo.
There are plenty of tube vids on how to oxidise wicks, you can also find info here
http://www.vapourtrails.tv
Also check out Romastino and Igetcha69 on youtube. Here is a great forum for anything rebuildable
http://vapepit.net you will need to register though.
Here's a quick run down...
Roll wick.
Using either a lighter (slowest), blowtorch or gas cooker, hold the wick with needle nose pliers in the flame till it glows red, dip in water and repeat about 6 times (you can also drip some liquid on the wick and burn it off and harden it).
Or you can oxidise the wick on your device ... roll wick, roll coil round the wick, fit to atty, put atty on battery device and set to low volts/watts, pulse button on battery holder so the coil glows red (this may take a while as the coil need to glow all round), once done, up the power to 3.7v (7.5ish watts?), then keep pulsing for a minute or two, add liquid and vape.