Watercooling advice

Difference between the blocks is the new "EN" plating method. There have been people with problems of nickel flaking off.

As for the tubing cutter, mines different but I'm sure that one will be able to cut something a few mm bigger. You can just squeeze the tubing to fit in if it is limited in how wide it can open.
 
So the cheaper ones better? :p

k :p

Nah the EN one is "supposedly" better, but users have been still getting problems with that new plating. Personally I'd say it's down to their loop. Maybe something passing electricity through the block or what they mix in their loop.
 
oh, I was talking about sleeving each of the clables individually. ie, an 8 pin means 8 cables ;)

Just get a variety of sizes and an ATX pin remover ;)
 
Yeah I knew what you were talking about :p

But I mean like, some are 2.5mm others 4mm, 10mm etc, what cables use 2.5mm what cables use 10mm etc? :p

If it takes 50m that'll be about £45-50, so just about same price to buy pre-braided cables :p
 
The BitFenix Alchemy range comes with each cable braded, and if its 50m that'll cost same as the pre-braided ones, so easier to buy pre-braided :p
 
Back
Top Bottom