Select 2.66 and start upping the FSB.
Remember to set the MCH voltage to +0.1v for the 4 sticks again.
Sweet ok, will get onto that, should I change the DRAM overvoltage control at all ?
Select 2.66 and start upping the FSB.
Remember to set the MCH voltage to +0.1v for the 4 sticks again.
Depends on which OCZ memory you have.
What is your CPU voltage at? It shouldn't need more than 1.35v at the most atm.
probably worth letting orthos or similar run for 30 mins or so check the temps and see if its stabl-ish give yourself an idea of where you are then up the FSB a bit more and do the same... if it fails the 30 min orthos then start upping vcore
Just the CPU atm.
May I just say well played Cob for helping out with this one?! It's what makes these boards great!![]()