***Official Gigabyte Z77X-UP4 TH, Z77X-UP5 TH and Z77X-UP7 discussion thread***

is the higher the better? if so you got better cpu?:P

btw i used this





and no voltage drop at 3.9





but


1.104 goes to this when idel
1.056 full load no drops

normal?

less core on full load? more on idel?
 
Last edited:
HDD I/O slows to crawl here any ideas installed bit defender and the hard drive io is very slow




ssd drive and is installed on the 6gps port along with the other hdd non ssd 6gbps


this has been going for 4 hours now mate just done the same install took him 20mins?

 
Last edited:
Last edited:
wazza300 said:
you could probably get 3.9ghz on 1.03v? to do that try cpu v on normal, llc on low and -0.010 dvid

you might have to use a lower llc as it might add extra to whats being used in cpu voltage,just stress cpu and lower to get to 1.03v(or lower cpu load voltage than what auto is using)

if its not stable then id leave it on auto
Click to expand...

would it be best to aim for 4ghz and just switch turbo mode off?
 
just doing a test v 1.115@ 4ghz seems stable just it doesnt like to stay at 1.6ghz idel jumps a lot dunno if thats a bug with cpuz no background processes running that i can see


but coretemp its stable 1.6ghz at idel no jumping
 
Last edited:
just running at test at 1.110v 10mins in all good will leave it running

while watching the vcore in easytune for a split second it went to 1.044
but has been stable line on 1.056 on load

temps 53/52 room temp is about 100c heating on full blast


i have left LLC on low is that fine dont use the offset
 
Last edited:
small problem anyone used skype get that static noise it has cracking in it also not just a
smooth static sound which is normal on skype

version skype 6.1

I removed the reltek drivers and installed windows drivers and no cracking static just a smooth static sound which is normal?

I guess it has something to do with the sound quality not sure what max windows
drivers support with sound quality

but even with the realtek drivers i did try and change the sound formats but still cracking
i have to have the output on really low just to not hear it


Realtek High Definition Audio Driver R2.70 is the driver installed
someone said there was a beta about cant seem to fin it!
 
Last edited:
hey guys do i need to really install the Marvell SATA Controller Drivers?
because each start up it holds windows boot up so i removed them

i can just let windows install a driver will it effect it much?
 
New Official Gigabyte skin for CPU-Z >> http://www.cpuid.com/downloads/cpu-z/1.62.2-oc-setup-en.exe

Source

be43638f11642664.jpg
 
Could anyone help me with some OC settings for memory please (spec in sig) Would like 2133mhz or 2400mhz. Not a clue about Oc'ing memory, there's no options in BIOS for changing memory stuff.
 
You must log in or register to reply here.
Back
Top Bottom