PHANTEKS EVOLV X & P600S

Could someone please measure the PSU cutout window? Would like to know the minimum length a PSU needs to be to fill it out. Went back 12 pages and couldn't see any mention. Thanks!
 
Mcthommo said:
Would love to see the room in the foot of the case after front 360 rad to see if the 3.5 drive cage is possible as still tempted by this case
Click to expand...
I’ve got a 420 rad in mine, and can only get one set of 3.5 cages in the bottom. With the depth of rad an fans, there no rom for the other cage.
 
clone said:
@Rensin how difficult is it to do the wrap and could you show me the back of the panel you did?
Click to expand...

not too difficult if you have some decent vinyl. I've used cheap vinyl off ebay and can not get the vinyl to stick on some of the edges but the flat (front) parts look good. Using too much heat on the edges has torn the vinyl when streched.

I have looked at the 3m stuff but for matte white you need to buy a full roll unless anyone has a link to smaller cuts?
 
Rensin said:
not too difficult if you have some decent vinyl. I've used cheap vinyl off ebay and can not get the vinyl to stick on some of the edges but the flat (front) parts look good. Using too much heat on the edges has torn the vinyl when streched.

I have looked at the 3m stuff but for matte white you need to buy a full roll unless anyone has a link to smaller cuts?
Click to expand...
Cheers mate.
 
Italiux said:
Do you guys think this case would fit Alphacool NexXxoS ST30 Full Copper X-Flow 280mm Radiator in the top + EK-COOLSTREAM SE420 in the front?
Click to expand...

Don't see why not, as you can see here with a SE280 and a CE420 it is a fairly comfortable fit... given the SE420 is slimmer than the CE420 pictured there that should account for the slightly longer x-flow 280mm and leave plenty of room.
 
Decided to remove the vinyl from the edges so they are the original gun metal (I think the gun metal edges split the white quite nicely) , also added vinyl to the top panel. (edges will be cleaned up)

The feet will be done the same colour when next shutdown.

Apologies there not the best pics


 
Is there an adapter for 4pin RGB to D-RGB (3pin) for the strips at the front of the case?

My board only has 2x 4pin RGB connectors.

cheers
 
I've decided to improve PSU and front intake dust filters as in my opinion they are pretty useless especially since I own a cat.

PSU filter before mod:


PSU filter after mod:



Now just need to do the same for front dust filter...
 
Italiux said:
I've decided to improve PSU and front intake dust filters as in my opinion they are pretty useless especially since I own a cat.

PSU filter before mod:

PSU filter after mod:

Now just need to do the same for front dust filter...
Click to expand...

What did you use to replace the mesh? I cant even see the holes on mobile.
 
You must log in or register to reply here.
Back
Top Bottom