Project Helca Yár

So here it is with the rads in! (need some more compressions now... there goes another 10-20 quid but oh well :/)

IMAG0092.jpg


got some major re-organising to do with all my cable tidying. res + pump should be fitted by tuesday then I have to sort all the tubing lengths out... and finally leak test (hoping that theres no leaks when I attempted to flush my rads using my pump a couple of the fittings were leaking... and no matter what I did they wouldn't stop :c)
 
Looking good! how did she manage to wreck one, threaded it?

With those grommets you should be able to do a really good job with the cables. Keep it up and hopefully you wont have anymore broken parts.. :D
 
Ahah. well for some reason... I've hand tightened them as far as possible and she reckoned they had to go further so she got the pliers and completely stripped the paint and scratched the hell out of one of them. Atm I have two that are still on tubing that I can't undo and Idk why :/ ordered 8 more from EK gg to 30 quid D:
 
They are out of stock unfortunately as well mate D: btw 2x 120 fans do fit on the inside. :p I had a little issue with a bit on top that holds the filter in for trying to have one in pull outside the case. Tight fit though with a full rad.
 
Ollie1132 said:
They are out of stock unfortunately as well mate D: btw 2x 120 fans do fit on the inside. :p I had a little issue with a bit on top that holds the filter in for trying to have one in pull outside the case. Tight fit though with a full rad.
Click to expand...

Might use a 45mm Rad for the top and have push/pull then and use a 60mm in the bottom
 
That would work. But take the top part off and have a look at the bits that hold the filter in. They obstruct a fan if you try to put one in pull on top. (at least they way I tried to do it.)
 
Strange maybe I was trying to put it on wrongly. Doesn't matter too much now though. Will be fitting my res tonight and sorting out the platform for my pump to sit on soonish. Still have to find somewhere with the compressions I need. :/
 
And after quite an antagonizing wait.. I finally have all the compresssions I need.. so started putting it all together today. Just need to get the other end off the res so I can move the central tube... But it doesn't seem to want to budge :/
 
It an EK res? If so then its common for the top end of the res to be impossible to remove...without tools, put a pair of hens legs/water pump pliers on the top cap and grip the cylinder with your hand and turn, its a royal pita.
 
No idea Jay yet to actually get my system going. I need some rotary fittings (grr) and itll be done. Yeah it is pgi, suppose Ill have to get some damn tools now xD also entirely fill my res or leave air space?
 
Last edited:
You must log in or register to reply here.
Back
Top Bottom