• Notice regarding image hosts and attachments. See here.

Road Cycling Essentials

Status
Not open for further replies.
This are the Ultegra flightdeck shifters. Any idea which they are or how to check? I've had a quick look under the rubber hood but can't see them.

AnObY9mCQAA9Ram.jpg

Looks to be 6510. The 6600 ones I have here are different. £10.99 RRP each.

ST-6510 name plate and cover - right hand
Code: 6C8 9804

ST-6510 name plate and cover - left hand
Code: 6C8 9805

http://techdocs.shimano.com/media/t...ST/EV-ST-6510-1950A_v1_m56577569830728746.pdf
 
Just been reading reviews on the Michelin Krylions and there are a lot of people saying that fitting them was a nightmare as they're really tight. Had enough of that malarkey with my Gatorskins! I suppose it depends on the wheel in question but has anyone got any experience of this? My wheels are ALX300 (came with Specialized Allez Elite).
 
Krylions are quite tight but nothing compared to my previous Vitorria tyres. The pain of removal is off-set by the infrequency of punctures IMO. I would recommend a decent set of tyre levers just in case (such as these for example).
 
I think this might be the last pair of Michelin Pro 3 I buy. I got three punctures in the first couple of miles of the Kentish Killer and I'm pretty certain I know why now. The sticky surface picks up sharp debris and instead of flying off, it gets stuck in the surface. You then ride over it, over and over again, which works it through the surface and punctures your inner tube. This has now been consistent every time the road has been gritted or whenever there are roadworks that leave fine debris on the road. I can't rely on these tyres day-to-day so I think when they're worn out I'm going over to something else.

I'll take a picture of the surface of the tyre if I remember, but it's full of small slashes and holes. All the new ones have got a piece of sharp grit stuck inside them. I'd picked out about 5 bits on the last puncture but the tyre is just littered with debris again :(
 
I think this might be the last pair of Michelin Pro 3 I buy. I got three punctures in the first couple of miles of the Kentish Killer

:( I've just ordered some Pro 3 tyres after getting another puncture with my continental ultra races.
 
Michelin Lithion 2 for me, only ever hand punctures from potholes, ridden nearly every day for 4+ years!

great value too, although I wear the rear out pretty quick doing fixie skids...
 
I have a question about road bike sizing chaps...

I'm 6'4 and have been riding mountainbikes for 15yrs. Although I should be on a 22/23" MTB 'by the book', I never got on with larger bikes, the two most comfortable bikes I've owned were both 19" frames.

I'm thinking of getting myself a roadie since I don't get out on the dirt much anymore but am a little confused by the sizing, which is in cm. 19/20" translates to approx 50cm but this seems to be the very bottom end of the sizing on the bikes I've looked at.

Obviously my best bet is to go and sit on some bikes and see what feels best, just wondered what you guys thought?

Cheers :)
 
I've been using a pair of Pro 3s since Christmas and they've been fine!

Same here, I've had pro3's on the bike for about a year & had 2 puncture see in that time.
Just swopped over to continental Gp 4000 though as I fancied a change & had heard good things about them.
Time will tell, but the pro3's had served my well all through the winter commuting every day to work in all weather's.
 
Status
Not open for further replies.
Back
Top Bottom