I think I am safe.
I think you'll run into issues putting them all up the top, you're gonna have hoses over the top of other hoses and a lot of clutter to deal with, assuming they all can reach.
-
Competitor rules
Please remember that any mention of competitors, hinting at competitors or offering to provide details of competitors will result in an account suspension. The full rules can be found under the 'Terms and Rules' link in the bottom right corner of your screen. Just don't mention competitors in any way, shape or form and you'll be OK.
**AMD Fiji Thread**
- Thread starter Boomstick777
- Start date
I think you'll run into issues putting them all up the top, you're gonna have hoses over the top of other hoses and a lot of clutter to deal with, assuming they all can reach.
Associate
Soldato
Kaap, you're buying the case specifically for that purpose? Don't you have a loop lol? EK blocks are ready to shift come NDA lift.
Man of Honour
Soldato
I'm building one into a Silverstone GD09.
Man of Honour
You may get away with 2 Kaaps.
As you're getting 4, wait for the blocks
Tubes on the cards are 400mm plus their rad thickness which should be enough but if I want a bit of slack I can use extra fans as well in push/pull which gives another 25mm.
If that is not enough I can just take the top 480mm rad out of the loop and attach the cards to that. I love quick disconnects in a water loop.
This is my setup, so i will just install the Fury rad in the place of the back fan.
Looks lovely!
Caporegime
My fan set-up is this.
Default NZXT case fans, apart from the bottom one, so 200mm top, 200mm front, 140mm rear, and on the bottom ive added a 120mm Noctua NF A14 FLX as an intake, the 200mm that was an intake on the side panel, ive disconnected, as it put my card temp up by a degree, so ill just remove the 140mm from the rear as said, and pop the Rad there.
Could probably put it at the top next to the 200mm (if it would reach that far up), but would be a faff on, as to get the top of the case off, id have to remove both side panels, and the front panel, but for the rear, i'll only need to take the other side panel off, to disconnect the fan
Default NZXT case fans, apart from the bottom one, so 200mm top, 200mm front, 140mm rear, and on the bottom ive added a 120mm Noctua NF A14 FLX as an intake, the 200mm that was an intake on the side panel, ive disconnected, as it put my card temp up by a degree, so ill just remove the 140mm from the rear as said, and pop the Rad there.
Could probably put it at the top next to the 200mm (if it would reach that far up), but would be a faff on, as to get the top of the case off, id have to remove both side panels, and the front panel, but for the rear, i'll only need to take the other side panel off, to disconnect the fan
Last edited:
Soldato
I love quick disconnects in a water loop.
It's a crime to build a loop without them
Tubes on the cards are 400mm plus their rad thickness which should be enough but if I want a bit of slack I can use extra fans as well in push/pull which gives another 25mm.
If that is not enough I can just take the top 480mm rad out of the loop and attach the cards to that. I love quick disconnects in a water loop.
I look forward to seeing your spaghetti junction
Soldato
Pfft, additional points of failure I don't need
Hi, I have around 8 in my loop in total and have never had to replace one in two years
Caporegime
Do we know how long the hoses are to the rad ?
Man of Honour
400mm
400mm.
Caporegime