Clocking Advice/Tips Needed

Guys,

I lapped my Freezer Pro 7 and the Q6600 but when I stuck it all back together the temps rocketed 70 plus. I reset the CPU and cooler and found that one of the clips was not catching the mobo hole so I ordered a new cooler.

I now have installed the new cooler (un-touched) and the temps have only dropped 5 deg per core, is that OK?

Idle was at:

49
48
45
45

Now its, well as I write this:

46
46
43
43

Is the differance between each core normal as above or am I thinking that the lapping made things worse?

Regards.
 
Hi,

No I just used wet and dry paper until what I thought was flat and checking with a sharp blade and a background light.

I might get the CPU back out and draw a jack cross of sorts and start rubbing with 1500 paper, see what goes that way.

Regards.
 
Well I used 1500 and drew a jack as a guide and rubbed 10 times in all directions till the jack was removed.

Did this a few times but the base is not like a mirror as examples i've seen here.

Anyway, my temps are:

Load with OCCT:
59 58 56 54

Idle:
40 39 37 36

Tried to get all core temps the same but how far do you go in re-lapping?

Currently clocked to 3200.

Regards.
 
Back again,

Lapped my chip but not my new Freezer 7 cooler and since I've lapped it the temps are OTT.

Have reapplied silver to the middle in a line and the temps are:

Idle:
50 51 48 48

Load Prime:
70 70 67 67

For the life of me I cant get the temps back down.

Any tips?
 
Hi Guys,

Its a P5K standard and I reapplied Arctic Silver as per their website and running as follows:

Temps idle: 48 46 44 44

Load with Prime is: 60 60 59 59 ish

Clocked at: 3520Mhz

I have 2 freezers here, one lapped and the current one Im using is standard, I've removed the fan from the old freezer and placed it over the top of the installed pro 7 so I have 2 CPU fans running.

Its holding temps but noisy as hell.

Might try a new cooler after Xmas.

Regards
 
Hi again,

Having a few problems of late and more help is called for.

I did the vdrop pencil mod and that worked a treat and now I dont see any drop at all, glad I did it but now running at 3600 as per attached pic.

The problem I have is when I run prime the temps hit 60 and has topped 71 on core 1 and 2 the system gives the BSOD and has rebooted.

Now, is it heat, ram, cooler or just actual settings?

Any ideas!

Regards.

tempmu0.jpg


Temps above are at idle.
 
Yes (OCZ 2GB Kit (2x1GB) DDR2 800MHz/PC2-6400 CL 4-4-4-15 PLATINUM XTC with LIFETIME WARRANTY).

The NB voltage is 1.55 I think, but I will reboot now and double check.

brb
 
Hi,

I've changed ram timings to 5-5-5-23 and the ram voltage is set at 2.10v and if needs be I'll up the ram voltage to 2.20v later.

I've just run prime and it ran for the first time without the BSOD or rebooting so I presume its a ram problem.

Here is a screen shot:

 
Last edited:
You must log in or register to reply here.
Back
Top Bottom