Dale said:
Dude, I've been using OCZ rev2 Plat for a while and unless it is an issue with my CPU (A64 4000+ San Diego) was wondering if i've just not been having the right mem timings.
What is your setup for your memory on the DFI if you don't mind sharing?
Cheers
Here goes although these might not be the best but they are as best as I can find with mine.
TCL: 2.5
TRCD:3
TRAS:6
TRP:3
TRC:9
TRFC:12
TRRD:3
TWR:2
TWRT:2
TRWT:2
TREF:1560
TWCL:1 (any higher than 1 and it locks the ram up then have to clear CMOS)
BANK INT: ENABLE
SKEW CONTROL: Doesn't seem to make much difference.
DRIVE STRENGTH: Has to be weak 3 or 4 other settings crash
DATA STRENGTH: 2
MAX ASYNC: 8
READ PREAMBLE:5
IDLE COUNTER:128 - 256
R/W BYPASS:16X
32 BIT GRAN: DISABLE.
These are stable at 240- 270 fsb
I find the dynamic counter and the bank int, to not seem to do anything maybe they are for higher clocks.
The tref values are totally different for this 704-2 BT BIOS the most stable I find is 1560 whereas with all the other BIOS' it has been either 3072 or 1168.