***The Vapers Lounge*** 2.0

Status
Not open for further replies.
I have the soft cell cut off set to 3.2v on my Dual 18650 DNA200, at 55w on a 0.08ohm dual twisted TI coil with 70w pre heat, it shows weak battery once the cells get to about 3.5v due to battery sag, thats with Efest 2800mAh, 35a cells.
 
He 4's , was about what i thought i would get.Will set my soft cell cut off to 3.4v as i get about .5v sag with my TFV4 setup.
Mod resistance .014 ohms so set mod resistance to .011 ohms , checked cold resistance on both DNA 200 mods & they are with in .002 ohms( .084 & .086).
 
Ok going to buy the Eleaf Melo 2 tank for TC and ease of use unless some one has a better recommendation for a noob to TC wanting sub ohm and pre made coils? lol:D
 
The Uwell Crown is a great flavour sub ohm tank, it clouds well too, but on flavour it beats the Aromamizer and i can say that because ive been using the Crown with element key lime cookie and loving it, ive just build a new coil setup in the aromamizer and put the same juice in it and its only got 2/3rds the flavour of the crown. Naturally the juice itself can be different on different coils and tanks so its not definitive... but i personally notice a Big difference, i normally use the Aromamizer with my ADV and its great with that.. but not with the Element juices.
 
Last edited:
Ah damn, i hate that when it happens... i get my orders delivered to work... just in case.

I do normally but I won't be working there as of next week and because I wasn't sure when the Wismec would ship, figured it would be better to have it sent to home.
 
Torchy does some great batteries, i got 4 of the Efest 2800mAh 35amp cells for my Dual DNA200 off him and they are working well but he also does the 3000mAh Samsung 30Q's which are seemingly the best option at the moment.

Nice one, thanks. Just found Torchy's listing for the 3000mAh Samsung 30Q on ebay. £12.45 for two. Very good price.
 
If youre a member on UKvapers you can buy direct and save a little. ;)

Yep, been a member since 2013. :) I own a couple of Torchy 18350s that I bought beginning of last year, weren't very good but that's because they were low ampage. I bought through him via ebay, didn't think to buy direct from him. Will do this time :D
 
Made a coil from the 26g wire, reading 0.6ohm.
Was vaping great for a few hours then started spitting etc...
Mod still only reading 7.8W for this, anything higher and constant spitting/popping.
img shows 26awg, 5 wraps, 2mm i/d, with kanger included coil next to it.


3Wik2ITm.jpg.png


Sb4UYkWm.jpg


xM1clYJm.jpg
 
Last edited:
Was gonna hold off on the aromamizer but I broke my Lemo 2 :( had some titanium wire arrive so I could try TC, twisted two 24AWG strands, built a coil and went to put it in, the wires went in to the post holes, but not all the way to screw down, and got stuck. Tried to pull them in or out with pliers and the wires snapped on both ends, so the post holes are jammed. Looking down the screw holes I can see the wire has bent down and is definitely jammed. So, tried drilling them out - no dice, I simply can't drill through the titanium with a drill bit that small. My first instinct was to drill the holes a little larger when the wires were a little tight to begin with, but alas, I ignored it. Screw it, ordered an aromarizer from steam crave, early upgrade :p
 
Was gonna hold off on the aromamizer but I broke my Lemo 2 :( had some titanium wire arrive so I could try TC, twisted two 24AWG strands, built a coil and went to put it in, the wires went in to the post holes, but not all the way to screw down, and got stuck. Tried to pull them in or out with pliers and the wires snapped on both ends, so the post holes are jammed. Looking down the screw holes I can see the wire has bent down and is definitely jammed. So, tried drilling them out - no dice, I simply can't drill through the titanium with a drill bit that small. My first instinct was to drill the holes a little larger when the wires were a little tight to begin with, but alas, I ignored it. Screw it, ordered an aromarizer from steam crave, early upgrade :p

I think I've got a spare deck for A Lemo2 at home if you want it
 
Hi all, I started on vaping years ago and got my first one from Mirage Cigarettes in Sheffield in 2012/3 I think. Used it on and off but obviously the quality was nowhere near as good as it is now. I stopped on New Years Eve this year after a malfunction which resulted in me swallowing most of my liquid :eek:

Clearly I had every intention of replacing it but alas, never got round to it and I've been back on the rolleys since then. Save for reading through the forum and seeing what was decent a few weeks ago and what was value for money etc would anyone care to recommend something to replace roll-ups (golden virginia). Obviously decent battery, lasting coil and fairly harsh strength either by nicotine content or ampage. Aesthetics aren't important as I'm not going to be using it to look cool or create the most vapour in the room, it is primarily to kick the habit again, regardless of how long that takes.

I'm probably looking iro £75/100 for intial outlay.
 
And so has mine. Batteries in and it's now running the case analyser. Uploaded all my profiles from my VT200 so it's ready to go. Set the WH to 23.3 with 3 x 2100mAh VTC4s
Lovely looking mod. It's smaller than I thought but feel great in the hand.

Looking forward to when it's charged and I can get vaping on it.
 
I charged my Efest 2800mAh cells last night and brought them in to use this as i knew the supplied VTC4's would be flat.... the Efests dont work in the Wismec, im guessing the built in reverse protecting rings around the Positive ends is not making contact with the Efests , so now i have the VTC4's in and charging via USB, gonna be a while before i can take it for a toot.
 
Status
Not open for further replies.
Back
Top Bottom