Watercooled Case Gallery

Uh oh. I should not have come here. I should not have come HERE!

Currently spending myself up to water cool. Hardest part is gonna be grabbing a block for my CPU and card
 
I have the pump on PWM mode so I couldn't say the Volts, however the pump runs on a curve so that it is at around 1350rpm at idle, upto 3500 at gaming and then 4500 if I am rendering/heavy workloads
the only noise I hear is the motor spinning up or down. I haven't heard the popping noises of the trapped air bubbles for a good week since I installed the loop
 
Evolve-Finished-19.jpg
 
Some lovely rigs here and Samsung - great work. Such a smart looking colour combination and everything compliments each other perfectly :)
 
Some truly stunning builds in here, definitely learned a few things ready for my first watercooled build in a few weeks time. How difficult is it to get the hard tubing right though guys? I know it's more expensive to use than flexible tubing anyway, but just wondering how much waste you usually end up with from messed up bends etc? Cheers :)
 
Cool. Not as bad as I thought then cheers Samsung, although judging by how awesome your build is you could probably double it to take my incompetence into account!
 
Thanks for the kind words. I ordered a load extra in preparation for messing up a few times and ended up with quite a bit spare. I decided against acrylic as I heard its abit harder to work with and used PETG. If you notice I have used quite a few angle fittings to make the tubing runs need less bends as some were impossible without them.

The outlet on the CPU to the inlet on the Ram I attempted quite a few times without any angles but with the multiple bends so close to each other just wouldn't work. Each time you made a new bend the one before would deform or it was impossible to judge and look clean.

Personally I wouldn't recommend using hardline first time but get a build or two under your belt. It may look neater and it seems the fashion currently but lots of soft builds look just as nice when someone spends their time on the lay out.

Good luck though and if you need any advice along the way just post on the WC section as there is a wealth of experience to help.
 
eObtU08.jpg
Nothing special, however I'm proud of it since it's my first attempt at a custom loop. apologies for the poor quality photo, it's the best I could do.
 
Digipact said:
eObtU08.jpg
Nothing special, however I'm proud of it since it's my first attempt at a custom loop. apologies for the poor quality photo, it's the best I could do.
Click to expand...

Your first attempt at a loop and you went hardline? :o Looks good though.

Also is that 1 360 rad for GPU and CPU, What temps you getting?
 
You must log in or register to reply here.
Back
Top Bottom