Soldato
I've been rewiring mine, and I've got a new coil. And new clip ons. And some new seat fabric.
Last edited:
What did you do to your bike today?
- Thread starter edd1e
- Start date
Associate
Agreed. Probably one of the worst I've had in a while
Soldato
Agreed. Was out yesterday (albeit "commuting" and not for pleasure) and it was glorious, although I'm fairly rural, so there's quite a bit of crap on some of the smaller roads from beet harvesting and general farming, just take it easy on those roads, and you're good to go!
Soldato
I took it for a final run, topped tank up with super unleaded, back home, bit of a wipe down, bottle of redex in the tank, on stands on a solar trickle charger until next year.
Redex? Do I need this?
Man of Honour
No, brim with super is more than good enough.
Soldato
I find it helps in the spring when you restart it. Each to their own.
Soldato
Seeing as the engine is out anyway and the head has now been off a couple times, thought I'd check the valve clearances. Luckily I only need 14 new shims.......
At least I can reuse two of the existing ones! Ye, all 16 are outside of spec (too tight). Still, bike is on 34k and I have no record of when they were last checked. Ho hum, more spends on the rebuild!!! Annoyingly a lot of the "kits" only have x3 of each size. I need x7 2.80mm ones!! (plus 1 x 2.70 3 x 2.75 4 x 2.85 1 x2.90 - I can reuse a 2.90 and a 2.85 from the ones already in there)
At least I can reuse two of the existing ones! Ye, all 16 are outside of spec (too tight). Still, bike is on 34k and I have no record of when they were last checked. Ho hum, more spends on the rebuild!!! Annoyingly a lot of the "kits" only have x3 of each size. I need x7 2.80mm ones!! (plus 1 x 2.70 3 x 2.75 4 x 2.85 1 x2.90 - I can reuse a 2.90 and a 2.85 from the ones already in there)
Last edited:
Soldato
Gave my 2018 KTM 1290 SAR a face lift with MotoProWorks vinyl kit. Very happy with the results, feels like a new bike. I've fitted vinyl before so wasn't too bad, some swearing but as long as you have the right kit, makes sure the surface is clean and take your time its not too hard a job. Finished it off with a 3 year ceramic coat.
Before
After
Before
After
Last edited:
