Time for a new case...for lots of rads!

I don't think you can, from the looks of it the most you'd fit in the bottom would be 480+280, or 480+360 in the front.
 
That'd be disappointing, wouldn't be any better than my TJ11 (which I don't particularly like).
I'll wait until a bit more official info on the 900D is out, then if it's not better I'll probably just get a LD PC-V8.
 
If you don't like the Tj11 you can always donate it to me :o

But I know what you mean, if it isn't priced well that 1% of enthusiasts they claim to be aiming for will turn their noses up at it and go look at CL/LD.
 
Any word on official pricing?

Edit: tech specs list 7 expansion slots and only support upto eatx???
 
Last edited:
Just watched that video, from what i heard, 480 up top, 480 + 280 in the bottom + 360 in the front and even room for one where the rear exhaust fan is...........well, if you can't cool an overclocked pc in that, i don't think anything will ;)
 
You can't cool dual cpus with it as by the spec it has no hptx/xl/10 slot support, what gives?? 7 slots doesn't even give you quad card support. Really hope it's a typo on spec.
 
Quad card? As in 4 gpu's? My switch has 9 slots but board only goes down to 7th slot it's a eatx board (G1 sniper 3) and has quad sli.

If i'm reading that right lol ;)

What are you cooling with it all?
 
I'm not running quad cards (4x dual slot = 8 slots) but corsair gave the impression this case was aimed at those with big boards and big gpu setups. My board runs the full 10 slots :p

Don't get me wrong it's a nice case the only saving grace for corsair now is that this comes in at tj07 pricing, any more then fail imo.

Ordering the phobya, had a few ideas of light mods to tidy up the internals and a window will be easy enough, will have around twice the amount of radiator in it then a 900D can handle :D
 
Perhaps a typo in the tech specs then!

Yep PL will be getting under way as soon as the case lands and I can start rad planning. At the mo its looking like 1080+360+360+280 :p
 
Haha, well I already own the 1080 and pair of 360's, I need something in the front so 280 for that but I guess adding the RX120 I have to that would just be greedy :p

I need to shorten tube routing for the 1080, so holes straight through the side pannel into the case. Will not be using the HDD racks either so I'll have a nice big open space for tubes and reservoirs and the likes :D I also may put some sort of motherboard tray extension here to clean up some of the cables.

The window is going to be easy, buy a sheet of acrylic the size of the side panel, drill 4 x 4mm mounting holes, job done!
 
Back
Top Bottom