What have you done to your car today?

spacer.jpg



came in today thermal spacer horsiesssss when i put it on that is :)
 
Acme said:
To stop heat transferring from the head to the plenum, thus reducing intake air temperature?
Click to expand...
Yup and solved design flaw of upper plenum that got corrected later on.
SK2-307-07-0400_05-800x533.jpg


From what I researched its best hp/torque mod one can do on VQ35DE engine :) With that intake and exhaust map looking 300+hp after rev up remap :)
 
Acme said:
That is impressive. :)
Click to expand...
ye for 100 bucks delivered and 1.5 hour job init :D there are few 8 12 16 mm ones. I went for 8 as its best on all revs the taller spacer gains move up in revs and You loose bottom. And what is nice about Z its torque compared to all my angle grinders.happy cruising around town with diesel like rps. Where teg was 3500rpm minimum even at 30mph on 4th gear :D

Needs light Flywheel BAD. Not sure what to get first Clutch or remap :P

But in general VQ35 engines are case ofget bolton get map You are done. At lest on NA :)

@grudas
looks good
 
Frozennova said:
Way more than that, it changes plenum volume and runner lengths.Runner lengths can have a noticeable affect on the torque curve (You generally sacrifice some low down torque for an increase at higher RPM
Click to expand...

I'm not even sure I understand how a plenum works...

In my world the air goes in through the throttle body into the intake manifold and into the cylinders. What does the plenum do?
 
Got quoted £500 to fix the 7G tronic, which is a reconditioned TCU from MB with the same warranty as a new one plus the transmission oil & filter kit, and labour. Could've been much worse. They said it wasn't worth fixing the existing TCU as it'd cost almost as much. Brand new TCU would've been £750 with labour and oil & filter kit.

The amount of paperwork they have to send to MB for it is ridiculous though, as it's a theft sensitive part. Multiple copies of utility bills, ID, V5, etc...
 
Spent a while battling to get my oil filter cap undone. It's in such a crappy place on my car and you get barely any movement with a socket wrench - perhaps 1/4 of a turn if you're lucky, with scraped knuckles too. Finally did it and then just so happened to notice my bumper has a ridiculous amount of stone chips on it. Annoying when I've only had the car 2 months and it was nearly spotless back then.
 
Frozennova said:
Way more than that, it changes plenum volume and runner lengths.Runner lengths can have a noticeable affect on the torque curve (You generally sacrifice some low down torque for an increase at higher RPM
Click to expand...
Ye if im bothered/bored ill buy used lower plenum and do porting/matching on it. Seen people getting extra horsea there. Was thinking about grabbing kinetix upper one if i ould get my hands on used one for looks more than gains haha.

I know 1 thing. Fell in love with this japspeed exhaust with decats aound ******* awrsome and shots flamzzz deffo my thing. And i consider it quiet compared to what i had on all My Hondas haha
Like first time in years i can have conversation with peraon sitting next to me feels innatural to Me haha. Always been Me road point a point b ASAP.
Minus is im flooring it all the time to hear the exhaust there goes mpg buhahha
 
You must log in or register to reply here.
Back
Top Bottom